Removing A Hot-Swap Power Supply - IBM System x3530 M4 Installation And Service Manual

4. Reconnect the power cord and any cables that you removed.
5. Install PCI riser-card assembly 1 (see "Replacing a PCI riser-card assembly" on
page 329).
6. Install the air baffle (see Replacing the DIMM air baffle).
7. Install the cover (see "Replacing the server top cover" on page 67).
8. Reconnect the power cord and any cables that you removed.
9. Turn on the peripheral devices and the server.

Removing a hot-swap power supply

When you remove or install a hot-swap power supply, observe the following
precautions.
Statement 5
CAUTION:
The power control button on the device and the power switch on the power
supply do not turn off the electrical current supplied to the device. The device
also might have more than one power cord. To remove all electrical current from
the device, ensure that all power cords are disconnected from the power source.
320
System x3530 M4 Type 7160: Installation and Service Guide