3. Install the screws to secure the USB connector board to the USB assembly.
4. From the front of the server, slide the USB assembly into the USB slot until it
5. Connect one end of the USB cable to the connector on the USB connector
6. Align the front video connector (if available) with the slot on the server and
7. Connect the video/USB cable to the connector on the system board.
8. Secure the USB cable with any cable clips in the server.
9. Replace the cover (see "Replacing the server top cover" on page 67).
338
System x3530 M4 Type 7160: Installation and Service Guide
clicks into place.
board; then, connect the other end of the USB cable to the connector on the
system board. Route the USB cable as shown in the following illustration.
install the two screws to secure it to the server.