IBM System x3530 M4 Installation And Service Manual page 95

Select this choice to enable or disable devices from taking control of the
boot process. The default is Disable.
- Legacy Thunk Support
Select this choice to enable or disable UEFI to interact with PCI mass
storage devices that are non-UEFI compliant.
- Infinite Boot Retry
Select this choice to enable or disable Infinitely retry the Legacy Boot order.
- BBS Boot
Select this choice to enable or disable legacy boot in BBS manner.
– System Security
Select this choice to view or configure Trusted Platform Module (TPM)
support.
– Integrated Management Module
Select this choice to view or change the settings for the integrated
management module.
- Power Restore Policy
Select this choice to view or enable the POST watchdog timer.
- Commands on USB Interface Preference
Select this choice to enable or disable the Ethernet over USB interface on
IMM.
- Network Configuration
Select this choice to view the system management network interface port,
the IMM MAC address, the current IMM IP address, and the host name;
define the static IMM IP address, subnet mask, and gateway address;
specify whether to use the static IP address or have DHCP assign the IMM
IP address; save the network changes; and reset the IMM.
- Reset IMM to Defaults
Select this choice to view or reset IMM to the default settings.
- Reset IMM
Select this choice to reset the IMM settings.
– Recovery
Select this option to configure recovery settings.
– Storage
Select this option to see all the storage device settings.
– Network
Select this choice to view or configure the network device options, such as
iSCSI, PXE, and network devices. There might be additional configuration
choices for optional network devices that are compliant with UEFI 2.1 and
later.
– Driver Health
Select this option to view the status of the controllers in the system as
reported by their corresponding drivers.
v Date and Time
Select this choice to set the date and time in the server, in 24-hour format
(hour:minute:second).
This choice is on the full Setup utility menu only.
v Start Options
Chapter 3. Configuration information and instructions
79