IBM System x3530 M4 Installation And Service Manual page 183

Table 13. IMM2 error messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
v If an action step is preceded by "(Trained technician only)," that step must be performed only by a trained
technician.
806f0113-0301xxxx A bus timeout has
occurred on system
CPU 1 PECI.
806f0113-0302xxxx A bus timeout has
occurred on system
CPU 2 PECI
806f0413-2582xxxx A PCI PERR has
occurred on system
%1.(%1 =
CIM_ComputerSystem.
ElementName)
Error This message is for
the use case when
an implementation
has detected a Bus
Timeout.
Error This message is for
the use case when
an implementation
has detected a Bus
Timeout.
Error A PCI PERR has
occurred. (Sensor =
PCIs)
1. Reseat the microprocessor, and then
restart the server.
2. Replace microprocessor n.
(n = microprocessor number)
1. Reseat the microprocessor, and then
restart the server.
2. Replace microprocessor n.
(n = microprocessor number)
1. Check the PCI LED. See more
information about the PCI LED in
"Light path diagnostics LEDs" on
page 109.
2. Reseat the affected adapters and
riser cards.
3. Update the server firmware (UEFI
and IMM) and adapter firmware.
Important: Some cluster solutions
require specific code levels or
coordinated code updates. If the
device is part of a cluster solution,
verify that the latest level of code is
supported for the cluster solution
before you update the code.
4. Replace the adapters.
5. Replace the riser cards.
Chapter 4. Troubleshooting
167