IBM System x3530 M4 Installation And Service Manual page 278

10. From a command line, type filename-s, where filename is the name of the
11. Turn off the server and disconnect all power cords and external cables, and
12. Move the UEFI boot recovery jumper back to the primary position (pins 1 and
13. Reinstall the server cover, and then reconnect all the power cables.
14. Restart the server.
In-band automated boot recovery method
Note: Use this method if the BOARD LED on the light path diagnostics panel is lit
and there is a log entry or Booting Backup Image is displayed on the firmware
splash screen; otherwise, use the in-band manual recovery method.
1. Boot the server to an operating system that is supported by the firmware
2. Perform the firmware update by following the instructions that are in the
3. Restart the server.
4. At the firmware splash screen, press F3 when prompted to restore to the
Out-of-band method: See the IMM documentation.
262
System x3530 M4 Type 7160: Installation and Service Guide
4. Move the jumper from pins 1 and 2 to pins 2 and 3 to enable the UEFI
recovery mode.
5. Reinstall the server cover; then, reconnect all power cords.
6. Restart the server. The power-on self-test (POST) starts.
7. Boot the server to an operating system that is supported by the IBM Flash
UEFI Update package that you downloaded.
8. Perform the firmware update by following the instructions that are in the
firmware update package readme file.
9. Copy the downloaded firmware update package into a directory.
executable file that you downloaded with the firmware update package.
then remove the server cover.
2).
update package that you downloaded.
firmware update package readme file.
primary bank. The server boots from the primary bank.