Replacing The Front Video Connector - IBM System x3530 M4 Installation And Service Manual

Hide thumbs Also See for System x3530 M4:

Table of Contents

Replacing the front video connector

To replace the front video connector board, complete the following steps:

1. Read the safety information that begins on page Safety and "Installation

2. Align the video connector with the slot on the server and install the two screws

System x3530 M4 Type 7160: Installation and Service Guide

guidelines" on page 30.

to secure it to the server.

Note: Refer to the illustrations below for 2.5-inch and 3.5-inch hard disk drive

bays models respectively. Depending on your server model, align the video

connector from inside or outside the server.