Table of Contents
Advertisement
Rev 2.0
Thermostat Control Screen
The Thermostat Control screen is a Secondary Screen which is a sub-screen of the Status & Control
Screen.
Selection of the HVAC system type can be made on this page. Status of the selected type along with the
default settings is also shown prominently.
achieved in the TMI (See TMI Advanced Settings page). In addition, a software reset may be applied to the
thermostat by pressing the left button (See Reset Actuations). See Figure 10 below.
Field Definitions – Thermostat Control
1 - Reset
-
Holding this button down for three seconds or greater will cause the thermostat to perform a
software reboot.
2 - Type
-
Provides selection of either Fuel Burner (default) or Heat Pump HVAC systems. When
selecting between either Fuel Burner or Heat Pump or between Heat Pump and Fuel
Burner, the HVAC Mode must be set to OFF prior to selecting the opposite setting.
(See HVAC Screen above or the Status & Control Page in the TMI Section.)
Fuel Burner
Heat Pump
Changing specific parameters for each type can only be
Screen 3.1
Thermostat Control
HVAC Type: Fuel Burner
Heat Ctrl:
Cool Ctrl:
1
Reset
2
Figure 10 – Thermostat Control Screen
- Selects fossil fuel systems which includes oil or gas fired boilers or
furnaces.
- Selects electric heat pump HVAC system type.
Enable
Enable
Type
Back
Page 17 of 54
Advertisement
Table of Contents
