Table of Contents
Advertisement
Rev 2.0
Advanced Settings Page
The Advanced Settings Page allows an installer customize the thermostat for the user accoding to the user's
HVAC requirements.
A Submit must be issued by the user to apply all changes made in the Control column. The status of
most functions will be updated upon clicking the Refresh button.
Thermostat Configuration
HVAC System Type
Specifies the type of HVAC system. Provides selection of either Fuel Burner (default) or
Heat Pump HVAC systems. When selecting between either Fuel Burner or Heat Pump
or between Heat Pump and Fuel Burner, the HVAC Mode must be set to OFF prior to
selecting the opposite setting. (See LCD HVAC Screen above or the Status & Control
Page in this TMI Section.)
Status and Control:
Fuel Burner (default) – The HVAC system burns fossil fuels (e.g. gas or oil). Typically the
system includes either an oil or gas fired boiler or furnace.
Heat Pump – Specifies that the HVAC system is based on an electric compressor.
Figure 25 – Advanced Settings Page
Page 44 of 54
Advertisement
Table of Contents
Need help?
Do you have a question about the NT10e and is the answer not in the manual?
Questions and answers