Sensor Settings Page; Local Sensor; State - Proliphix NT10e Configuration Manual

Rev 2.0

Sensor Settings Page

The Sensor Settings Page allows the user to customize the thermostat for specific thermal sensing
requirements. Because the NT10e does not support external thermal sensors, this page is NOT available
on the NT10e Network Thermostat.
A Submit must be issued by the user to apply all changes made in the Control column. The status of
most functions will be updated upon clicking the Refresh button.

Local Sensor

State

Defines whether or not the internal thermostat thermal sensor is enabled. The internal
thermal sensor may be disabled if only remote sensing is desired.
Status and Control:
Disabled – The internal thermal sensor is disabled. No Local Sensor value is displayed on
the Status & Control Page.
Enabled (default) – The internal thermal sensor is enabled.
Figure 26 – Sensor Settings Page
Page 47 of 54