Temperature Status; Zone Temperature; Local (Temperature); Override - Proliphix NT10e Configuration Manual

Rev 2.0

Temperature Status

Zone Temperature

Current temperature of local sensor if temperature averaging is disabled.
Average temperature of any combination of Local, RS #1 (NT20e) or RS #2 (NT20e) if
temperature averaging is enabled. In Figure 15 above, the Local sensor and Remote
Sensor #2 (RS #2) are included in the average to determine the Zone Temperature. (See
Sensor Settings Page)
Status:
o
45

Local (Temperature)

Current temperature of local sensor. This field is grayed-out if the local thermostat sensor is
not included in temperature averaging. This field is not visible on the NT10e thermostat.
Status:
o
45
RS #1
Current temperature of Remote Sensor #1 if this remote thermal sensor is installed and
enabled. This field is grayed-out if RS #1 is not included in temperature averaging. (See
Sensor Settings Page). This field is not visible on the NT10e thermostat.
Status:
o
45
RS #2
Current temperature of Remote Sensor #2 if this remote thermal sensor is installed and
enabled. This field is grayed-out if RS #2 is not included in temperature averaging. (See
Sensor Settings Page). This field is not visible on the NT10e thermostat.
Status:
o
45

Override

Indicates whether Heat or Cool Settings (below) are different from the current scheduled
settings. Changes made to either the Heat or Cool Settings which force an override will
remain at those settings until the next scheduled Period change. At the Period change, the
settings for either/both Heat or Cool will then follow the schedule. (See Schedule Settings)
Status:
Override

Cool Setting

Current temperature programmed for the cooling (A/C) system. This will appear grayed-out
if the HVAC mode is set to Heat or Off (see HVAC Mode). This function will not be visible if
the thermostat is configured to be a Heat only controlling device. (See General Settings
Page)
Status and Control:
o
45

Heat Setting

Current temperature programmed for the heating system. This will appear grayed-out if the
HVAC mode is set to Cool or Off (see HVAC Mode). This function will not be visible if the
thermostat is configured to be a Cool only controlling device. (See General Settings Page)
o
F to 99 F
o
F to 95 F
o o
F to 120 F (120 F is displayed if no sensor is installed)
o o
F to 120 F (120 F is displayed if no sensor is installed)
o
F to 95 F
Page 25 of 54