Table of Contents
Advertisement
Rev 2.0
Fan Mode
Displays and controls the current state setting for the HVAC fan.
Status and Control:
Auto – Heating or Cooling system controls the operation of the fan
On – User forces the fan to the on state independent of the operation of the HVAC system.
Alarm Status
Low Temperature
Displays the current status of the low temperature alarm condition. The temperature has
fallen below a pre-programmed limit. After the occurrence of this alarm, the user must
repair the condition which caused the temperature to fall below the prescribed limit before
resetting this alarm. (See General Settings Page)
Status:
OK
Alert!
temperature threshold.
High Temperature
Displays the current status of the high temperature alarm condition. The zone temperature
has risen above a pre-programmed limit. After the occurrence of this alarm, the user must
repair the condition which caused the temperature to rise above the prescribed limit before
resetting this alarm. (See General Settings Page)
Status:
OK
Alert!
temperature threshold.
Filter Change
Displays a reminder to the user that the time interval between HVAC filter changes has
expired. The air filter(s) must be cleaned or replaced. The user must change the filter and
then reset this timer. (See General Settings Page)
Status:
OK
Required!
user. (See General Settings Page)
– No Low Temperature Alarm is present.
– The temperature monitored within the thermostat has dropped below the pre-set low
– No High Temperature Alarm is present.
– The temperature monitored within the thermostat has risen above the pre-set high
– No filter change is required.
– The HVAC filters require changing or cleaning as per the interval set by the
Page 27 of 54
Advertisement
Table of Contents
