Table of Contents
Advertisement
Rev 2.0
Network Settings Page
The Network Settings Page allows the user the ability to configure the approriate network parameters specific to
the user's local network.
A Submit must be issued by the user to apply all changes made in the Control column. The status of
most functions will be updated upon clicking the Refresh button.
Addressing
MAC Address
This is a factory assigned value installed in the thermostat which uniquely identifies the
thermostat on the local network for transmitting and receiving network information.
Status:
Always displayed in the format of 00:11:49:11:22:33, where 11:22:33 will be a unique value
for each thermostat.
IP Address Method
This field allows the user to select the method by which the thermostat will receive the
unique Internet Protocol address for the local network. IP addressing can be either
automatically assigned via a local DHCP server or manually (Static) assigned by the user.
(See IP Addressing Methods). After the initial configuration of the thermostat, assignment
of the IP address should be switched to Static to ensure a permanent IP address
assignment for Remote Management or for simplified local management.
Status and Control:
DHCP (default) – IP addressing method is DHCP assigned.
Figure 24 – Network Settings Page
Page 42 of 54
Advertisement
Table of Contents
