Installing The Thermostat; Required Tools - Proliphix IMT Series Installation Manual

Beta Draft Confidential
Overview
The Proliphix Internet Managed Thermostat (IMT) provides a rich set of innovative
features including the ability to configure settings through a graphical interface either
locally or from any remote location. The "c" model suffix thermostats can be
connected via secure wired Ethernet to a home, small business, or light commercial
data network, while the "w" model suffix thermostats support 802.11 b/g connections.
This guide describes how to physically install the IMT.
model-specific features that are important to note during the installation:
Table 1 IMT Features
Model
IMT550c
IMT550w

Installing the Thermostat

This section describes the required tools, guidelines, and installation instructions for
the IMT.
Preventing electrostatic discharge (ESD) — Static electricity may cause damage
to the components on the thermostat's circuit module. Do not remove the
Caution
thermostat from the protective bag until you are ready to install the thermostat.

Required Tools

The following tools are required to install the Proliphix thermostat:
#1 or #2 Phillips head screwdriver.
Drill with a 3/16" or 7/32" bit.
Punchdown tool (included with the thermostat).
Terminal block screw driver (included with the thermostat).
Proliphix Internet Managed Thermostat (IMT) Installation Guide, Release 1.0
Part No. 600-03100-000, Rev. 2
Wired 802.11 b/g
Ethernet wireless
X
X
Table 1 describes the
Humidity Aux Relays
Sensing (2)
X X
X X
Power
Method(s)
EPA
PoE
HVAC
EPA
HVAC
1