Table of Contents
Advertisement
Rev 2.0
Introduction
Congratulations!
You have purchased the most advanced and technically sophisticated thermostat
available today. The NT10e and NT20e are powered by Proliphix Network Power and are identical in
features with one exception; the NT20e supports two remote thermal sensors and the NT10e does not
support external thermal sensors.
Once the physical installation of the thermostat is complete you will perform much of the configuration
operations from the Proliphix Thermostat Management Interface (TMI) with your web browser. The Proliphix
TMI provides a sophisticated management capability to manage and control your Proliphix thermostats.
The Proliphix Network Thermostat also provides you the ability to perform many of the traditional functions
using the buttons located on the front of the unit. These buttons allow you to modify the temperature, enable
some basic HVAC functions and to view the thermostat's network configuration and status. Please review
the section entitled "Thermostat Device Interface" for more information on these functions.
This manual is organized into the following sections;
1. Thermostat Device Interface – Management and control capability at the thermostat.
2. Network Interconnect – Connecting your thermostat to your local network.
3. Thermostat Management Interface – Management and control capability through the web browser.
4. Warranty Information
Quick Setup
The remaining sections of this document describe in detail which settings and parameters must be
configured to access and control your Proliphix Network Thermostat through either the Thermostat Device
Interface or more comprehensively through the browser-based Thermostat Management Interface.
Proliphix recommends the following basic actions to ensure reliable operation of your thermostat. Please
refer to the above sections for a detailed understanding of how to perform these basic steps to enable these
functions.
Real Time Clock
Your Proliphix Network Thermostat comes directly from the factory with the real time clock disabled to
ensure longer battery life. You must enable the real time clock to provide you years of accurate
timekeeping on your thermostat. Please perform the following steps to enable your real time clock;
1. Proceed directly to the General Settings TMI page.
2. Without changing any parameters, press Submit.
IP Addressability
Your Proliphix Network Thermostat comes directly from the factory set to support the DHCP mode for
assigning an IP address to your thermostat. See the DHCP Assigned IP Addresses section in the Network
Interconnect chapter. Proliphix recommends that immediately after retrieving the IP address and port
number from your thermostat (Thermostat Device Interface – Status & Control Screen – Network Status
Screen) you should;
Page 5 of 54
Advertisement
Table of Contents
