Mode Setting For Head Maintenance Signal (Output) - Epson CW-C6000A Technical Reference Manual

Mode setting for head maintenance signal (output)

[Format]
^S(CNA,M,c
[Parameter] c
Description
c = Mode setting
[Function]
Configure the mode setting for the head maintenance signal.
Value for parameter c
D/0
1
E/2
[Initial value]
0
[Examples of command transmissions]
Set the head maintenance signal to "Normal: High, When head maintenance is in progress: Low".
The ^JUS command must be used to save the settings to the non-volatile memory in the printer.
An example of the command transmission is shown below. It is sent via USB or Ethernet from the computer.
^XA
^S(CNA,M,1
^JUS
^XZ
D/E/0/1/2
Turn the head maintenance signal (pin 21) OFF (not output).
Set the head maintenance signal (pin 21) as follows:
Normal: High, When head maintenance is in progress: Low.
Set the head maintenance signal (pin 21) as follows:
Normal: Low, When head maintenance is in progress: High.
Definition range
Description
Chapter 3 Commands
3
27