Switch The Printer To Maintenance Mode; Important; Entering Adhesive Material Maintenance Removal Mode - Epson ML-13000 User Manual

ML-13000 User's Manual
Note:
The belt rotation speed can be adjusted using the Belt speed dial on the front panel.
We recommend setting the belt rotation speed to a somewhat slower speed if this is your first time performing work.
Workflow
1. "Entering Adhesive Material Maintenance Removal Mode" on page 298
2. "Product curing" on page 299
3. "Preparing the Felt" on page 302
4. "Setting the felt" on page 303
5. "Ensuring safety" on page 306
6. "Removing Glue" on page 306
7. "Belt surface cleaning" on page 312
8. "Clean-up" on page 314
You can watch a video of the procedure on YouTube.
https://support.epson.net/p_doc/94e/

Entering Adhesive Material Maintenance Removal Mode

Switch the printer to maintenance mode.

c

Important:

Normally, you cannot operate the control panel when any cover is open or the belt cleaning unit is pulled out.
Therefore, if you return to the home screen during glue maintenance operations, you will not be able to return to
Maintenance mode until you close the front cover or the belt cleaning unit. Make sure you do not touch the panel
until you are ready, as it may result in performing curing again, setting the jigs again, or failure of glue maintenance
operations.
A
From the Maintenance screen on the control panel, touch Maintenance - Adhesive Material Maintenance.
Maintenance
298