Adj Top & Bottom - Epson Stylus PRO 7000 Service Manual

EPSON Stylus Pro 7000
ADJ TOP & BOTTOM
This function sets the distances between the P FRONT sensor and heads,
cutter and heads, as well as the P EDGE sensor and heads. You can also use
this function to adjust the top, bottom, and side margins.
1. Make sure "Adj. Top & Bottom" appears, and press the Enter button.
2. The printer prints a check pattern (lines) and cuts off the paper at a fixed
distance.
3. After the printing operation is finished, measure the top, bottom, and
right (HP) side margins using a ruler. Press the item select (Paper Feed) +/
- buttons to enter each of these measurements in 0.1mm increments.
4. After entering the measurements, press the SelecType or Item button
until "Bottom Length xx.xmm" appears, and then press the Enter button.
Printing Pattern
Top Length
Bottom Length
Side Margin
[SelecType]/[Item]
Figure 5-35. Margin Adjustment Operation
Adjustment
3.0mm
[Enter]
End
15.0mm
adjustment/
next menu
3.0mm
Self-Diagnostic Mode Menus
Bottom
margin
Top margin
Figure 5-36. Measuring Sections/Margin Adjustment Pattern
Revision B
Side
margin
Feed
direction
190