Removing/Installing Rear Wiring Harness - Invacare HMV Zoom 300 Service Manual

SECTION 11—CONTROLLER

Removing/Installing Rear Wiring Harness

NOTE: For this procedure, refer to FIGURE 11.4.
NOTE: To install the rear wiring harness, reverse this procedure.
1. Disconnect the following from the controller.
• 6-way rear harness connector
• 8-way rear harness connector
• 4-way motor connector
2. Disconnect the batteries. Refer to Removing/Installing the Batteries on Zoom 300 on
page 86 or refer to Removing/Installing the Batteries on Zoom 400 on page 88.
3. Disconnect the circuit breaker. Refer to Replacing/Resetting the Circuit Breaker on
page 76.
4. On Zoom 400 only:
A. Remove the four (4) mounting screws securing the battery connectors to the frame.
B. Remove the rear harness connector from controller tray.
5. Remove the two (2) screws and locknuts securing the charger connector to the
controller tray.
6. Lift the wiring harness from the controller tray.
Zoom 300 and Zoom 400
74
Part No 1122167