Invacare HMV Zoom 300 Service Manual page 87

5. Install two (2) batteries into the battery tray.
6. Connect the wiring harness to the new batteries in the following order (Detail "B" of
FIGURE 12.2):
A. NEGATIVE (-) BLACK battery cable to the NEGATIVE (-) battery terminal/post on
the LEFT battery.
B. POSITIVE (+) RED battery cable to POSITIVE (+) battery terminal/post on the right
battery.
C. WHITE Battery Cable (Jumper) to the POSITIVE (+) battery terminal/post on the
left battery and the NEGATIVE (-) battery terminal/post on the right battery.
7. Connect the RED and BLACK battery connector to the wiring harness assembly.
Tighten securely.
8. Secure batteries in the battery tray using the hook-and-loop battery strap (Detail "A"
of FIGURE 12.2).
9. Reinstall the rear shroud. Refer to Removing/Installing the Rear Shroud on page 44.
10. Reinstall the seat. Refer to Removing/Installing the Seat on page 34.
NOTE: New batteries MUST be fully charged BEFORE using, otherwise the life of the batteries
will be reduced.
11. If necessary, charge the batteries. Refer to Charging the Batteries on page 97.
DETAIL "A" - REMOVING/
INSTALLING THE
BATTERIES
NOTE: Seat and
Rear Shroud not
shown for clarity.
Battery Tray
DETAIL "B" - BATTERY
WIRING HARNESS
50-Amp Fuse
POSITIVE (+) RED
Battery Cable
POSITIVE (+) RED
Battery Terminal
NEGATIVE (-) BLACK
Battery Terminal
FIGURE 12.2 Removing/Installing the Batteries on Zoom 300
Part No 1122167
Battery
Batteries
Strap
Installed
RIGHT
BATTERY
SECTION 12—BATTERIES AND CHARGER
Battery Tray
RED and BLACK
Battery Connector
LEFT
BATTERY
87
Batteries
Removed
WHITE Battery
Cable (Jumper)
NEGATIVE (-) BLACK
Battery Cable
NEGATIVE (-) BLACK
Battery Terminal
POSITIVE (+) RED
Battery Terminal
Zoom 300 and Zoom 400