Removing/Installing the Headlight
NOTE: This procedure is for the Zoom 400 only.
NOTE: For this procedure, refer to FIGURE 8.6.
Removing
1. Remove the rear tiller shroud. Refer to Removing/Installing the Rear Tiller Shroud on
page 46.
2. Disconnect the headlight connector from the PC board connector (Detail "A" of
FIGURE 8.6).
3. Remove the locknut, washer and mounting bolt that secure the headlight to the
headlight mounting bracket (Detail "B" of FIGURE 8.6).
4. Remove the headlight.
Installing
1. Insert the headlight cable and connector through the hole in the upper tiller shroud
(Detail "B" of FIGURE 8.6).
2. Install the headlight on the headlight mounting bracket using the locknut, washer and
mounting bolt. Securely tighten.
3. Plug the headlight connector to the PC board connector (Detail "A" of FIGURE 8.6).
4. Install the rear tiller shroud. Refer to Removing/Installing the Upper Tiller Shroud on
page 44.
DETAIL "A"
Headlight
Headlight
Connector
Part No 1122167
PC Board
Connector
FIGURE 8.6 Removing/Installing the Headlight
DETAIL "B"
Hole in Upper
Tiller Shroud
Mounting
Bolt
47
SECTION 8—TILLER
Headlight
Mounting Bracket
Washer
Locknut
Headlight
Headlight Cable
and Connector
Zoom 300 and Zoom 400