Section 13-Maintenance And Troubleshooting; Storing The Scooter; Suggested Maintenance Procedures - Invacare HMV Zoom 300 Service Manual

SECTION 13—MAINTENANCE AND
TROUBLESHOOTING
After ANY adjustments, repair or service and BEFORE use, make sure that all
attaching hardware is tightened securely - otherwise, injury or damage may occur.
Before performing any maintenance, adjustment or service, turn power OFF and
remove key from ignition.
DO NOT overtighten hardware attaching to the frame. This could cause damage to
the frame.

Storing the Scooter

Use care in storage. DO NOT allow any metallic objects to contact the exposed
terminals.
1. Before storing the scooter for prolonged periods of time, perform the following.
A. Charge the batteries. Refer to Charging the Batteries on page 97.
B. Remove the batteries. Refer to Removing/Installing the Batteries on Zoom 300 on
page 86 or refer to Removing/Installing the Batteries on Zoom 400 on page 88.
2. Before use, recharge batteries. Refer to Charging the Batteries on page 97.

Suggested Maintenance Procedures

1. Before using the powered scooter, make sure all nuts and bolts are tight. Check any
parts for damage or wear and replace. Check all parts for proper adjustment.
2. Ensure that batteries are properly maintained and charged as required.
3. The wheels and tires should be checked periodically for cracks and wear, and should
be replaced by a qualified technician if damaged.
4. Regularly check for loose nuts and/or bolts in the front and drive wheels. If loose, have
them adjusted by a qualified technician.
5. Clean dirt, dust and grease from exposed components.
6. Periodically have the bearings of the front wheel checked to make sure they are clean
and free from moisture.
Part No 1122167
SECTION 13—MAINTENANCE AND TROUBLESHOOTING
WARNING
WARNING
99
Zoom 300 and Zoom 400