Removing/Installing The Brake Release Lever; Removing; Installing - Invacare HMV Zoom 300 Service Manual

7. On Zoom 400 only - Assemble the scooter. Refer to Disassembling/Assembling the
Zoom 400 on page 105.
8. Install the rear shroud. Refer to Removing/Installing the Rear Shroud on page 30.
9. Install the seat. Refer to Removing/Installing the Seat on page 19.
NOTE: Zoom 300 shown. Zoom
400 transaxle removes/installs
the same way.
Swingarm
Assembly
Washer
Cotter Pin
Drive Wheel

Removing/Installing the Brake Release Lever

NOTE: For this procedure, refer to FIGURE 10.2.

Removing

1. Remove the seat. Refer to Removing/Installing the Seat on page 19.
2. Remove the rear shroud. Refer to Removing/Installing the Rear Shroud on page 30.
3. On Zoom 400 only - Disassemble the scooter. Refer to Disassembling/Assembling the
Zoom 400 on page 105.
4. Remove the cotter pin and washer that attach the brake release lever to the lever
mounting bracket on the transaxle.
5. Twist off the rubber tip from the end of the brake release lever.
6. Remove the brake release lever by sliding it out of the controller tray.

Installing

1. Slide the brake release lever through the slot in the controller tray.
2. Slide the brake release lever into the slot on the lever mounting bracket on the
transaxle.
3. Install the rubber tip onto the end of the brake release lever.
4. Install the washer and cotter pin to secure the brake release lever to the transaxle.
Part No 1122167
Washer
Drive
Shaft
Glide
Bearings
Viscous
Element
FIGURE 10.1 Removing/Installing the Transaxle
SECTION 10—TRANSAXLE
Transaxle
Assembly
65
Swingarm and
Caster Assembly
Viscous Element
Base Frame
Zoom 300 and Zoom 400