Installing/Removing The Safety Flag; Installing; Removing - Invacare HMV Zoom 300 Service Manual

SECTION 15—SCOOTER ACCESSORIES

Installing/Removing the Safety Flag

WARNING
The installation of the safety flag onto the back of the scooter seat significantly
increases the length of the scooter. When turning the scooter or swiveling the
scooter seat, it is important to take note of this increased length - otherwise, injury
and/or damage to the surrounding property may result.
NOTE: For this procedure, refer to FIGURE 15.4.

Installing

1. Install the bracket into the accessory tube located on the back of the seat.
2. Install mounting knob to secure the bracket in place. Securely tighten.
3. Install safety flag into bracket.

Removing

1. Remove the safety flag from the bracket.
2. Remove the mounting knob that secures the bracket in place.
3. Remove the bracket from the accessory tube located on the back of the seat.
Mounting Knob
Seat
Safety Flag
Bracket
Accessory Tube
FIGURE 15.4 Installing/Removing the Safety Flag
111
Part No 1122167 Zoom 300 and Zoom 400