Installing/Removing The Crutch/Cane Holder; Installing; Removing - Invacare HMV Zoom 300 Service Manual

SECTION 15—SCOOTER ACCESSORIES

Installing/Removing the Crutch/Cane Holder

WARNING
The installation of the crutch/cane holder onto the back of the scooter seat signifi-
cantly increases the length of the scooter. When turning the scooter or swiveling
the scooter seat, it is important to take note of this increased length - otherwise,
injury and/or damage to the surrounding property may result.
NOTE: For this procedure, refer to FIGURE 15.3.
NOTE: The Crutch/Cane Holder, Safety Flag and Oxygen Holder all install into the accessory
tube; ONLY one (1) of these may be installed at a time.

Installing

1. Install the crutch/cane holder into the accessory tube located on the back of the seat.
2. Install the mounting knob to secure the crutch/cane holder in place. Securely tighten.
3. Align the slot on the base with the hook on the crutch/cane holder and slide base down
into position.

Removing

1. Remove the crutch/cane holder from the accessory tube.
2. Remove the mounting knob that secures the crutch/cane holder in place.
3. Remove the crutch/cane holder from the accessory tube.
Crutch Cane Holder
Mounting
Knob
Seat
Accessory Tube
Hook
Base
FIGURE 15.3 Installing/Removing the Crutch/Cane Holder
110
Zoom 300 and Zoom 400 Part No 1122167