Installing - Invacare HMV Zoom 300 Service Manual

DETAIL "A" - ZOOM 300
Mounting
Screws
Base Frame
Locknuts
4-way Motor Connector
connects HERE
Controller
on Zoom
300
6-way Rear Harness
Connector connects HERE

Installing

1. Ensure that the power is off and the key is removed from the ignition.
2. Install the controller on the controller tray using three (3) mounting screws and
locknuts. Securely tighten.
3. Connect the following to the controller (Detail "C" of FIGURE 11.1):
• 6-way rear harness connector
• 8-way rear harness connector
• 4-way motor connector
4. On Zoom 400 only:
A. Install the battery charger. Refer to Replacing the Charger on page 92.
B. Assemble the scooter. Refer to Disassembling/Assembling the Zoom 400 on
page 105.
Part No 1122167
Controller
Controller
Tray
Locknut
DETAIL "C" - LOCATION OF CONNECTORS
8-way Rear Harness
Connector connects
HERE
FIGURE 11.1 Removing/Installing the Controller
SECTION 11—CONTROLLER
DETAIL "B" - ZOOM 400
Controller
Mounting
Screws
Controller
Tray
Controller on
Zoom 400
8-way Rear Harness
Connector
connects HERE
69
Locknuts
Scooter Frame
6-way Rear Harness
Connector
connects HERE
4-way Motor Connector
connects HERE
Zoom 300 and Zoom 400