Removing And Installing Wheels (4-Wheel Version And Rear Wheels On 3-Wheel Version) - Invacare Leo Service Manual

27.
Remove chassis by pulling it upwards.
28. Remove front wheel (see chapter 6.2).
29.
Pull fork out. This can require a lot of strength, as
fork (2) can be difficult to detach from the steering
head holder (1).
30.
Remove clamp (1).
1509707-E
31. Loosen fork bolt (2).
32. Remove retaining ring.
33. Remove serrated washer.
34. Remove knurled screw (3).
35. Pull steering column up and out.
36.
Remove ball bearing (1).
37. Install parts in reverse order.
38. Test all functions.
4.7.2 Removing and installing wheels (4-wheel
version and rear wheels on 3-wheel
version)
WARNING!
Risk of accident
When parking the mobility device on its support
wheels it is no longer slowed by the engine
brake. The mobility device can roll away out
of control.
– Place the mobility device rear frame on a
supporting wooden block before you remove
wheels.
When removing, note position of small parts such
as screws and washers. Put small parts down so
that they can be installed in right sequence.
• 17 mm wrench
• Rubber hammer
• Flat screwdriver
• 17 mm self-locking nut
• Block of wood
1. Secure mobility device against rolling away.
2. Position block of wood under the frame in the vicinity
of the battery box.
Service
19