Disassembling/Assembling The Zoom 400; Disassembling - Invacare HMV Zoom 300 Service Manual

Refer to Removing/Installing the
Batteries on Zoom 300 on page 50
FIGURE 14.1 Disassembling/Assembling the Zoom 300

Disassembling/Assembling the Zoom 400

NOTE: For this procedure, refer to FIGURE 14.2.

Disassembling

1. If installed on scooter, remove the front basket. Refer to Removing/Installing the Front
Basket on page 64.
2. Remove the seat. Refer to Removing/Installing the Seat on page 34.
3. Remove the rear shroud. Refer to Removing/Installing the Rear Shroud on page 44.
4. Remove the batteries. Refer to Removing/Installing the Batteries on Zoom 400 on
page 53.
5. Disconnect the 4-housing motor [located under marker label # 1] connector from the
controller (Detail "B" of FIGURE 14.2).
Part No 1122167
SECTION 14—TRANSPORTING
Refer to Removing/Installing
the Seat on page 34
Refer to Removing/Installing
the Rear Shroud on page 44
Refer to Removing/Installing the
Front Basket on page 64
Refer to Adjusting the
Tiller Angle on page 43
105
Zoom 300 and Zoom 400