SECTION 5—ARMS
SECTION 5—ARMS
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service, turn power off and
remove key from ignition.
Removing/Installing/Adjusting Arms
Removing/Installing
NOTE: For this procedure, refer to FIGURE 5.1.
NOTE: Reverse this procedure to install the arms.
1. Loosen adjustment knob that secures the arm to the arm support bracket.
2. Remove the arm from the arm support bracket.
3. If necessary, repeat STEPS 1-2 to remove the remaining arm.
Arm
Arm Mounting Tube
Adjustment Knobs
Arm Support Bracket
FIGURE 5.1 Removing/Installing/Adjusting Arms
25
Part No 1122167
Zoom 300 and Zoom 400