Transport; Transport - General Information; Dismantling The Scooter For Transport; Removing/Installing The Battery Box - Invacare Colibri User Manual

Invacare® Colibri

7 Transport

7.1 Transport - General information

WARNING!
Risk of severe or fatal injuries in the event
of a traffic accident if this mobility device is
used as a vehicle seat! It does not fulfill the
requirements of ISO 7176-19:2001.
– Under no circumstances should this mobility
device be used as a vehicle seat or to transport
the user in a vehicle.

7.2 Dismantling the scooter for transport

Please proceed as follows to dismantle the scooter for
transport:
1. Remove the seat. Refer to 4.5 Disengaging the seat to
rotate it or remove it, page 22.
2. Remove the battery box. Refer to 7.2.1
Removing/Installing the battery box, page 36.
3. Remove the drive unit. Refer to 7.2.2 Removing the
drive unit, page 37.
4. Fold the tiller down to the lowest locked position. Refer
to 4.7 Adjusting the tiller angle, page 23.

7.2.1 Removing/Installing the battery box

CAUTION!
Risk of strains from lifting heavy parts!
– Use proper lifting techniques.
36
CAUTION!
Risk of injury from unsecured scooter parts
Removing the battery box will release the
LITE-LOCK™ mechanism allowing the front frame
assembly to separate from the rear frame
assembly.
– Do not lift or move the scooter without the
battery box unless you want to disassemble
it. Refer to 7.2 Dismantling the scooter for
transport, page 36.
Removing the battery box
1. Remove the seat. Refer to 4.5 Disengaging the seat to
rotate it or remove it, page 22.
2.
Grab the handle of the battery box, pull the battery box
latch A with your thumb and remove the battery box.
Installing the battery box
1. Remove the seat. Refer to 4.5 Disengaging the seat to
rotate it or remove it, page 22.
2. Holding the battery box handle, carefully lower the
battery box on to the battery tray in the scooter.
3. Press down the battery box to engage the connector on
the battery box with the connector on the scooter base.
1576371-C