Adjusting The Tiller Angle; Replacing Handgrips - Invacare HMV Zoom 300 Service Manual

Adjusting the Tiller Angle

Ensure that tiller is properly adjusted before driving the scooter.
After making any tiller angle adjustments and before use, the tiller MUST be
securely locked into position. Otherwise, a fall from the scooter could occur causing
bodily injury and/or damage to the scooter. Gently, push/pull against tiller to ensure
that the tiller is securely engaged into the adjustment plate.
NOTE: For this procedure, refer to FIGURE 8.2.
NOTE: The powered scooter has an adjustable
tiller. The tiller locks into a position that is most
comfortable for you. The tiller also folds down
for transportation and storage.
1. Pull up on the tiller release lever
located under the right tiller handle.
2. Push/pull the tiller to the desired angle
and release the tiller release lever.
3. Gently, push/pull against tiller to
ensure that the tiller is securely
engaged into the locking mechanism.
NOTE: The tiller is locked in position when an
audible "click" is heard.

Replacing Handgrips

NOTE: For this procedure, refer to FIGURE 8.3
1. Cut the hangrip along the tiller handle.
2. Remove the cut handgrip from the tiller
handle.
3. Spray the inside of the new handgrip
with hairspray.
4. Slide the new handgrip onto the tiller
handle.
5. Repeat STEPS 1 and 4 for the other
handgrip.
Part No 1122167
WARNING
Up to
Unlock
Down to
Lock
FIGURE 8.2 Adjusting the Tiller Angle
Handgrip
FIGURE 8.3 Replacing Handgrips
43
SECTION 8—TILLER
Tiller Release Lever
Right Tiller
Handle
Tiller Assembly
Tiller Handle
(Under the Handgrip)
Zoom 300 and Zoom 400
Tiller