Replacing The Tiller Wiring Harness - Invacare HMV Zoom 300 Service Manual

Replacing the Tiller Wiring Harness

NOTE: For this procedure, refer to FIGURE 8.13 and FIGURE 8.14.
1. Turn power off and remove the key from the ignition.
2. Remove the seat. Refer to Removing/Installing the Seat on page 19.
3. Remove the rear shroud. Refer to Removing/Installing the Rear Shroud on page 30.
4. Perform one (1) of the following to remove the batteries:
• For Zoom 300 - Refer to Removing/Installing the Batteries on Zoom 300 on page 86.
• For Zoom 400 - Refer to Removing/Installing the Batteries on Zoom 400 on page 88.
5. Remove the front shroud. Refer to Removing/Installing the Front Shroud on page 31.
6. Disconnect the tiller wiring harness connector from the rear wiring harness
(FIGURE 8.13 for Zoom 300, FIGURE 8.14 for Zoom 400).
7. Mark the positions of the tie-wraps for replacing them later.
8. Cut the tie-wraps securing the tiller wiring harness to the frame.
NOTE:
• For the Zoom 400 - Refer to FIGURE 8.14.
• For the Zoom 300 - Refer to FIGURE 8.13.
NOTE: The scooter may have to be elevated on blocks to access all tie-wraps.
9. Remove the tiller wiring harness from the scooter.
10. Secure the new tiller wiring harness to the frame with tie-wraps at the positions
marked.
NOTE: The scooter may have to be lifted to access all tie-wrap points.
11. Connect the tiller wiring harness connector to the rear wiring harness connector
(FIGURE 8.13 for Zoom 300, FIGURE 8.14 for Zoom 400).
12. Replace the front shroud. Refer to Removing/Installing the Front Shroud on page 31.
13. Perform one (1) of the following to install the batteries:
• For Zoom 300 - Refer to Removing/Installing the Batteries on Zoom 300 on page 86.
• For Zoom 400 - Refer to Removing/Installing the Batteries on Zoom 400 on page 88.
14. Replace the rear shroud. Refer to Removing/Installing the Front Shroud on page 31
15. Replace seat. Refer to Removing/Installing the Seat on page 19.
Part No 1122167
55
SECTION 8—TILLER
Zoom 300 and Zoom 400