Section 6-Shrouds; Removing/Installing The Rear Shroud; Removing; Installing - Invacare HMV Zoom 300 Service Manual

SECTION 6—SHROUDS
SECTION 6—SHROUDS
After ANY adjustments, repair or service and BEFORE use, make sure that all
attaching hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service, turn power OFF and
remove key from ignition.

Removing/Installing the Rear Shroud

NOTE: For this procedure, refer to FIGURE 6.1.

Removing

1. Remove the seat. Refer to Removing/Installing the Seat on page 19.
2. Disengage the hook-and-loop strips securing the rear shroud to the frame by pulling
up on the shroud.
3. Lift the rear shroud off the seat post.

Installing

1. Align the tabs on the rear shroud with the slots in the front shroud.
2. Place rear shroud on the frame and press down slightly to engage the hook-and-loop
strips on the rear shroud (not shown) with those on the scooter frame.
3. Install the seat. Refer to Removing/Installing the Seat on page 19.
DETAIL "A" - ZOOM 300
Hook-and-Loop
Strips
Frame
Location
Front
of Slots
Shroud
Zoom 300 and Zoom 400
WARNING
Rear
Shroud
Tabs
Seat Post
FIGURE 6.1 Removing/Installing the Rear Shroud
DETAIL "B" - ZOOM 400
Seat Post
Hook-and-Loop
Strips
Frame
Front Shroud
30
Rear Shroud
Tabs
Hook-and-Loop Strips
Part No 1122167