SECTION 8—TILLER
Removing/Installing the Rear Tiller Shroud
NOTE: This procedure is for the Zoom 400 only.
NOTE: For this procedure, refer to FIGURE 8.5.
Removing
1. Remove the four (4) mounting screws that secure the rear tiller shroud to the front
tiller shroud.
Installing
1. Secure the rear tiller shroud to the front tiller shroud using the four (4) mounting
screws. Securely tighten.
Mounting Screws
Lower Tiller Shroud
Mounting Screws
FIGURE 8.5 Removing/Installing the Rear Tiller Shroud
Zoom 300 and Zoom 400
46
Front Tiller
Shroud
Part No 1122167