SECTION 7—WHEELS AND CASTERS
Removing/Installing the Front Wheel
NOTE: For this procedure, refer to FIGURE 7.2.
NOTE: Take note of position and orientation of wheel and mounting hardware before removing.
Removing
1. Turn power off and remove the key from the ignition.
2. Place the front of the powered scooter up on blocks so that the front wheel is off the
ground.
3. Remove the mounting screw, locknut and two (2) spacers that secure the front wheel
to the fork.
4. Remove front wheel from fork.
Installing
Front wheel MUST be mounted in the lower mounting holes for both the Zoom 300
and Zoom 400 - otherwise injury may result.
NOTE: Before installing the front wheel, check the fork for bending. If bent, replace the fork. Refer
to Removing/Installing the Fork on page 37.
1. Align front wheel with the lower fork mounting holes.
2. Secure the front wheel to the fork using the mounting screw, locknut and two (2)
spacers.
3. Securely tighten the front wheel mounting hardware.
Lower Fork
Mounting Hole
Spacer
Locknut
Zoom 300 and Zoom 400
WARNING
FIGURE 7.2 Removing/Installing the Front Wheel
Fork
36
Mounting Screw
Spacer
Front Wheel
Part No 1122167