Section 10-Rear Shroud; Removing/Installing The Rear Shroud; Removing; Installing - Invacare 300 Owner's Operator And Maintenance Manual

SECTION 10—REAR SHROUD
SECTION 10—REAR SHROUD
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure that all
attaching hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service, turn power OFF and
remove key from ignition.

REMOVING/INSTALLING THE REAR SHROUD

NOTE: For this procedure, refer to FIGURE 10.1.

REMOVING

1. Remove the seat. Refer to Removing/Installing the Seat on page 34.
2. Lift the rear shroud off of the frame post.

INSTALLING

1. Align tabs on the rear shroud with the slots (not shown in figure) in the front shroud.
2. Place rear shroud on the frame and press down slightly.
3. Install the seat. Refer to Removing/Installing the Seat on page 34.
DETAIL "B" - ZOOM 400
DETAIL "A" - ZOOM 300
Rear Shroud
Rear Shroud
Tabs
Seat Post
Tabs
Frame
Seat Post
Frame
Front Shroud
Front Shroud
FIGURE 10.1 - REMOVING/INSTALLING THE REAR SHROUD
™ ™ 44
Zoom 300 and Zoom 400 Part No. 1118395