Show Etherchannel - Cisco WLC 5700 Series Command Reference Manual

show etherchannel

show etherchannel

To display EtherChannel information for a channel, use the show etherchannel command in user EXEC
mode.
show etherchannel [channel-group-number | {detail | port | port-channel | protocol | summary }] | [detail|
load-balance | port| port-channel| protocol| summary]
Syntax Description
channel-group-number
detail
load-balance
port
port-channel
protocol
summary
Command Default
None
Command Modes
User EXEC
Command History
Release
Cisco IOS XE 3.2SE
Usage Guidelines
If you do not specify a channel group number, all channel groups are displayed.
In the output, the passive port list field is displayed only for Layer 3 port channels. This field means that the
physical port, which is still not up, is configured to be in the channel group (and indirectly is in the only port
channel in the channel group).
Examples This is an example of output from the show etherchannel channel-group-number detail command:
Controller> show etherchannel 1 detail
Group state = L2
Ports: 2
Layer 2/3 Command Reference, Cisco IOS XE Release 3E (Cisco WLC 5700 Series)
44
Maxports = 16
(Optional) Channel group number. The range is 1 to 128.
(Optional) Displays detailed EtherChannel information.
(Optional) Displays the load-balance or frame-distribution
scheme among ports in the port channel.
(Optional) Displays EtherChannel port information.
(Optional) Displays port-channel information.
(Optional) Displays the protocol that is being used in the
channel.
(Optional) Displays a one-line summary per channel group.
Modification
This command was introduced.
Layer 2/3 Commands
OL-32323-01