Flash On Time - Datalogic Gryphon I GD4100 Reference Manual

Flash On Time

This feature specifies the ON time for the indicator LED while in Flash Mode. The selectable
range is 100 to 9,900 milliseconds (0.1 to 9.9 seconds), in 100 millisecond increments.
Follow these instructions to set this feature.
1. Determine the desired setting in milliseconds.
2. Divide the desired setting by 100 (setting is in 100ms increments). Pad the result with
3. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming
4. Scan the barcode: SELECT FLASH ON TIME SETTING.
5. Scan the appropriate two digits from the keypad in Appendix E, Keypad representing the
NOTE
6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming
This completes the procedure. See Table
Table 4. Flash On Time Setting Examples
STEP ACTION
1 Desired Setting
Divide by 100 (and pad
2 with leading zeroes to yield
two digits)
3
4
Scan Two Characters From
5
Appendix E, Keypad
6
Product Reference Guide
leading zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
Mode.
duration which was determined in the steps above. You will hear a two-beep indication
after the last character.
If you make a mistake before the last character, scan the CANCEL
barcode to abort and not save the entry string. You can then start
again at the beginning.
Mode.
500ms
05
Scan ENTER/EXIT PROGRAMMING MODE
Scan SELECT FLASH OFF TIME SETTING
'0' and '5'
Scan ENTER/EXIT PROGRAMMING MODE
4 for some examples of how to set this feature.
EXAMPLES
5200ms (5.2
1,000ms (1 sec.)
sec.)
10 52
'1' and '0' '5' and '2'
Flash On Time
9,900ms (9.9 sec.)
99
'9' and '9'
55