Install The Batteries - Datalogic Gryphon I GD4100 Reference Manual

Getting Started

Install the Batteries

To install or change the battery of your reader, you must:
1. With a screwdriver, unscrew the battery cover screw.
2. Unplug the three screws securing the battery holder, and unplug the white connector.
3. Carefully lift out the gold contacts circuit, and remove the battery holder while letting the
4. Remove the old battery from its place (if present), and insert the new battery in the same
5. Replace the battery holder, plug in the connector and return the contacts circuit to its pre-
NOTE
16
white connector pass through the hole in the battery holder (as shown in the picture
below).
position.
vious location.
When inserting the new battery into the handle, take care to position the battery
and the connector as shown.
Connec
Screw
Pass-through
hole
Screw
Screw
Gryphon™ I GD4100/GM4100