I 2 Of 5 Set Length 1 - Datalogic Gryphon I GD4100 Reference Manual

Symbologies

I 2 of 5 Set Length 1

This feature specifies one of the barcode lengths for
minimum label length if in
Mode. The length includes the barcode's check and data characters.
The length can be set from 2 to 50 characters in increments of two.
Follow these instructions to set this feature:
1. Determine the desired character length (from 2 to 50). The length must be an even num-
2. Pad the result with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20,
3. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming
4. Scan the barcode: SELECT I 2 of 5 LENGTH 1 SETTING.
5. Scan the appropriate two digits from the keypad in
NOTE
6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming
This completes the procedure. See Table
Table 27. I 2 of 5 Length 1 Setting Examples
STEP ACTION
1 Desired Setting
Pad with leading zeroes to
2
yield two digits
3
4
Scan Two Characters From
5
Appendix E, Keypad
6
260
Variable Length
ber.
etc.
Mode.
the length setting which was determined in the steps above. You will hear a two-beep indi-
cation after the last character.
If you make a mistake before the last character scan the CANCEL
barcode to abort and not save the entry string. You can then start
again at the beginning.
Mode.
2 Characters
02
Scan ENTER/EXIT PROGRAMMING MODE
Scan SELECT I 2 of 5 LENGTH 1 SETTING
'0' and '2'
Scan ENTER/EXIT PROGRAMMING MODE
I 2 of 5 Length
Mode, or the first fixed length if in
Appendix E,
27 for some examples of how to set this feature.
EXAMPLES
6 Characters 14 Characters
06 14
'0' and '6' '1' and '4'
Gryphon™ I GD4100/GM4100
Control. Length 1 is the
Fixed Length
Keypad, that represent
50 Characters
50
'5' AND '0'