Code 128 Set Length 1 - Datalogic Gryphon I GD4100 Reference Manual

Symbologies

Code 128 Set Length 1

This feature specifies one of the barcode lengths for
minimum label length if in
Mode. Length includes the barcode's data characters only.
The length can be set from 1 to 80 characters.
Follow these instructions to set this feature:
1. Determine the desired character length (from 1 to 80). Pad the number with leading
2. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming
3. Scan the barcode: SELECT CODE 128 LENGTH 1 SETTING.
4. Scan the appropriate two digits from the keypad in
NOTE
5. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming
This completes the procedure. See Table
Table 23. Code 128 Length 1 Setting Examples
STEP ACTION
1 Desired Setting
2
3
Scan Two Characters From
4
Appendix E, Keypad
5
236
Variable Length
zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
Mode.
the length setting which was determined in the steps above. You will hear a two-beep indi-
cation after the last character.
If you make a mistake before the last character, scan the CANCEL
barcode to abort and not save the entry string. You can then start
again at the beginning.
Mode.
01 Character
Scan ENTER/EXIT PROGRAMMING MODE
Scan SELECT CODE 128 LENGTH 1 SETTING
'0' and '1'
Scan ENTER/EXIT PROGRAMMING MODE
Code 128 Length
Mode, or the first fixed length if in
Appendix E,
23 for some examples of how to set this feature.
EXAMPLES
07 Characters 15 Characters
'0' and '7' '1' and '5'
Gryphon™ I GD4100/GM4100
Control. Length 1 is the
Fixed Length
Keypad, that represent
80 Characters
'8' AND '0'