Gs1 Databar™ Expanded Set Length 2 - Datalogic Gryphon I GD4100 Reference Manual

Symbologies
GS1 DataBar™ Expanded Set Length 2
This feature specifies one of the barcode lengths for
Length 2 is the maximum label length if in
in Fixed Length
The length can be set from 1 to 74 characters. A setting of 0 specifies to ignore this length (only
one fixed length).
Follow these instructions to set this feature:
1. Determine the desired character length (from 1 to 74). Pad the number with leading
2. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming
3. Scan the barcode: SELECT GS1 DataBar™ EXPANDED LENGTH 2 SETTING.
4. Scan the appropriate two digits from the keypad in
NOTE
5. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming
This completes the procedure. See Table
Table 40. GS1 DataBar™ Expanded Length 2 Setting Examples
STEP ACTION
1 Desired Setting
2
3
Scan Two Characters From
4
Appendix E, Keypad
5
334
Mode. Length includes the barcode's data characters only.
zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
Mode.
the length setting which was determined in the steps above. You will hear a two-beep indi-
cation after the last character.
If you make a mistake before the last character, scan the CANCEL
barcode to abort and not save the entry string. You can then start
again at the beginning.
Mode.
00 (ignore second
length)
Scan ENTER/EXIT PROGRAMMING MODE
Scan SELECT GS1 DataBar™ EXPANDED LENGTH 2 SETTING
'0' and '0'
Scan ENTER/EXIT PROGRAMMING MODE
GS1 DataBar™ Expanded Length
Variable Length Mode, or the second fixed length if
Appendix E,
40 for some examples of how to set this feature.
EXAMPLES
07 Characters 52 Characters
'0' and '7' '5' and '2'
Gryphon™ I GD4100/GM4100
Control.
Keypad, that represent
74 Characters
'7' and '4'