Keypad Select
This parameter specifies the character that has to be sent from the scanner when one of the three
keys are pressed. For example, when key1 is pressed a 0x3C '<' character is sent.
Follow these instructions to set this feature:
1. Determine the desired setting.
2. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming
3. Scan the barcode: DISPLAY KEYPAD SELECT.
4. Then read 3 HEX characters in the range 01-FE from the keypad in Appendix E, Keypad,
NOTE
Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming Mode.
Enable Keypad Select
Make a mistake? Scan the CANCEL barcode to abort and
not save the entry string. You can then start again at the
beginning.
Product Reference Guide
Mode.
corresponding to the left, center and right keys respectively.
If you make a mistake before the last character, scan the CANCEL bar-
code to abort and not save the entry string. You can then start again at
the beginning.
ENTER/EXIT PROGRAMMING MODE
$
DEFAULT
Disable Keypad
CANCEL
3C3D3E
Keypad Select
65