Intercode Delay - Datalogic Gryphon I GD4100 Reference Manual

Intercode Delay

Specifies the delay between labels transmitted to the host for this interface. The selectable range
for this feature is from 0 to 99 seconds.
Follow these instructions to set this feature:
1. Determine the desired setting.
2. Pad the number with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 =
3. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming
4. Scan the barcode: SELECT INTERCODE DELAY SETTING.
5. Scan the appropriate two digits from the keypad in Appendix E, Keypad, that represent
NOTE
6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming
This completes the procedure. See Table
Table 16. Wedge Intercode Delay Examples
STEP ACTION
1 Desired Setting
2 Pad with leading zero(es)
3
4
Scan Two Characters From
5
Appendix E, Keypad
6
Product Reference Guide
20, etc
Mode.
the duration which was determined in the steps above. You will hear a two-beep indica-
tion after the last character.
If you make a mistake before the last character, scan the CANCEL
barcode to abort and not save the entry string. You can then start
again at the beginning.
Mode.
No Delay
00
Scan ENTER/EXIT PROGRAMMING MODE
Scan SELECT INTERCODE DELAY SETTING
'0' and '0'
Scan ENTER/EXIT PROGRAMMING MODE
16 for some examples of how to set this feature.
EXAMPLES
5 Seconds 60 Seconds
05 60
'0' and '5' '6' and '0'
Intercode Delay
99 Seconds
99
'9' AND '9'
109