Label Id: Set Individually Per Symbology - Datalogic Gryphon I GD4100 Reference Manual

ISBN
ISBT128
ISSN
MSI
Plessey
S25
UPCA
UPCA P2
UPCA P5
UPCA P8

Label ID: Set Individually Per Symbology

To configure a Label ID individually for a single symbology:
1. Scan the ENTER/EXIT barcode.
2. Select Label ID position as either BEFORE (Enable as Prefix) or AFTER (Enable as suf-
3. Scan a barcode to select the symbology for which you wish to configure a custom Label
4. Determine the desired character(s) (you may choose up to three) which will represent the
5. Turn to the ASCII Chart on the inside back cover of this manual and find the equivalent
NOTE
6. Scan the ENTER/EXIT barcode to exit Label ID entry.
7. Scan the ENTER/EXIT barcode once again to exit Programming Mode.
This completes the steps to configure a Label ID for a given symbology.
Product Reference Guide
Symbology
fix) by scanning the appropriate barcode in the section "Label ID Control"on page 140.
Reference Figure 19 for Label ID positioning options if multiple identification features are
enabled.
ID from the section Label ID Symbology Selection, starting on page 141.
Label ID for the selected symbology.
hex digits associated with your choice of Label ID. For example, if you wish to select an
equal sign (=) as a Label ID, the chart indicates its associated hex characters as 3D. Turn to
Keypad, starting on page 407 and scan the barcodes representing the hex characters deter-
mined. For the example given, the characters '3' and 'D' would be scanned. More exam-
ples of Label ID settings are provided in Table 18.
If you make a mistake before the last character, scan the CANCEL
barcode to abort and not save the entry string. You can then start
again at the beginning.
USA Label ID set
I 490000
f 660000
n 6E0000
@ 400000
a 610000
s 730000
A 410000
A 410000
A 410000
A 410000
Label ID
EU Label ID set
@ 400000
f 660000
n 6E0000
Z 5A0000
a 610000
P 500000
C 430000
F 460000
G 470000
Q 510000
137