Display; Programming; Using The Programming Barcodes - Datalogic Gryphon I GD4100 Reference Manual

Getting Started

Display

The Gryphon GM4100 is available with an optional Display. The Display features 4 lines and
16 characters, and offers icons and three additional keys to allow a better interaction with a
remote host.
Fonts, contrast, backlight and other parameters can be configured for the Display. See
on page 60
Figure 15. Gryphon™ I Display

Programming

The reader is factory-configured with a set of default features standard. After scanning the
interface barcode from the
reader through use of the instructions and programming barcodes available in the
corresponding features section for your interface, and also the Data Editing and Symbologies
chapters of this manual.

Using the Programming Barcodes

This manual contains feature descriptions and barcodes which allow you to reconfigure your
reader. Some programming barcode labels, like the "Restore Custom Default Configuration"on
page 30, require only the scan of that single label to enact the change. Most of the programming
labels in this manual, however, require the reader to be placed in Programming Mode prior to
scanning them. Scan an ENTER/EXIT barcode once to enter Programming Mode. Once the
reader is in Programming Mode, you can scan a number of parameter settings before scanning
the ENTER/EXIT barcode a second time, which will then accept your changes, exit
Programming Mode and return the reader to normal operation.
28
and "Message Formatting" on page 379
Interfaces
There are some exceptions to the typical programming sequence described
above. Please read the description and setting instructions carefully when
configuring each programmable feature.
NOTE
for more information.
section, you can select other options and customize your
Gryphon™ I GD4100/GM4100
"Display"