Intercharacter Delay - Datalogic Gryphon I GD4100 Reference Manual

RS-232/USB-Com Interfaces

Intercharacter Delay

This parameter specifies the intercharacter delay between the end of one character and the
beginning of the next. The delay can be set within a range of zero (0) to 990 milliseconds in
10ms increments. A setting of zero specifies no delay.
To set the delay:
1. Determine the desired setting in milliseconds.
2. Divide the desired setting by 10 (setting is in 10ms increments). Pad the result with lead-
3. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming
4. Scan the barcode: SELECT INTERCHARACTER DELAY SETTING.
5. Scan the appropriate two digits from the keypad in
NOTE
6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming
This completes the procedure. See
Table 7. Intercharacter Delay Setting Examples
STEP ACTION
1 Desired Setting
Divide by 10 (and pad with
2 leading zeroes to yield two-
digits)
3
4
Scan Two Characters From
5
Appendix E, Keypad
6
80
ing zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
Mode.
the duration which was determined in the steps above. You will hear a two-beep indica-
tion after the last character.
If you make a mistake before the last character, scan the CANCEL
barcode to abort and not save the entry string. You can then start
again at the beginning.
Mode.
50ms
05
Scan ENTER/EXIT PROGRAMMING MODE
Scan SELECT INTERCHARACTER DELAY SETTING
'0' and '5'
Scan ENTER/EXIT PROGRAMMING MODE
Appendix E,
Table 7 for some examples of how to set this feature.
EXAMPLES
150ms
15
'5' and '0'
Keypad, that represent
600ms 850ms
60 85
0' and '0' '8' and '5'
Gryphon™ I GD4100/GM4100