Codabar Set Length 2 - Datalogic Gryphon I GD4100 Reference Manual

Codabar Set Length 2

This feature specifies one of the barcode lengths for
maximum label length if in
Length
length must include at least one data character.
The length can be set from 3 to 50 characters. A setting of 0 specifies to ignore this length (only
one fixed length).
Follow these instructions to set this feature:
1. Determine the desired character length (from 3 to 50 — or 0 to ignore this length). Pad
2. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming
3. Scan the barcode: SELECT CODABAR LENGTH 2 SETTING.
4. Scan the appropriate two digits from the keypad in
NOTE
5. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming
This completes the procedure. See Table
Table 36. Codabar Length 2 Setting Examples
STEP ACTION
Desired Setting (and pad
1
with leading zeroes)
2
3
Scan Two Characters From
4
Appendix E, Keypad
5
Product Reference Guide
Variable Length
Mode. The length includes the barcode's start, stop, check and data characters. The
the number with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20,
etc.
Mode.
the length setting which was determined in the steps above. You will hear a two-beep indi-
cation after the last character.
If you make a mistake before the last character, scan the CANCEL
barcode to abort and not save the entry string. You can then start
again at the beginning.
Mode.
00 Ignore This Length
Scan ENTER/EXIT PROGRAMMING MODE
Scan SELECT CODABAR LENGTH 2 SETTING
'0' and '0'
Scan ENTER/EXIT PROGRAMMING MODE
Codabar Length
Mode, or the second fixed length if in
Appendix E,
36 for some examples of how to set this feature.
EXAMPLES
07 Characters 15 Characters
'0' and '7' '1' and '5'
Codabar
Control. Length 2 is the
Fixed
Keypad, that represent
50 Characters
'5' AND '0'
305