Industrial 2 Of 5 Set Length 1 - Datalogic Gryphon I GD4100 Reference Manual

Symbologies

Industrial 2 of 5 Set Length 1

This feature specifies one of the barcode lengths for
is the minimum label length if in
Length
The length can be set from 0 to 50 characters.
Follow these instructions to set this feature:
1. Determine the desired character length (from 0 to 50). Pad the number with leading
2. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming
3. Scan the barcode: SELECT INDUSTRIAL 2 of 5 LENGTH 1 SETTING.
4. Scan the appropriate two digits from the keypad in the Keypad Appendix, that represent
5. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming
This completes the procedure. See the table below for some examples of how to set this feature.
Table 31. Industrial 2 of 5 Length 1 Setting Examples
STEP ACTION
1 Desired Setting
2 Scan ENTER/EXIT PROGRAMMING MODE
3 Scan SELECT INDUSTRIAL 2 OF 5 LENGTH 1 SETTING
Scan Two Characters From the
4
Keypad Appendix
5 Scan ENTER/EXIT PROGRAMMING MODE
278
Mode. Length includes the barcode's data characters only.
zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
Mode.
the length setting which was determined in the steps above. You will hear a two-beep indi-
cation after the last character.
If you make a mistake before the last character, scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the beginning.
NOTE
Mode.
00 Characters
'0' and '0'
Industrial 2 of 5 Length
Variable Length Mode, or the first fixed length if in
EXAMPLES
07 Characters
'0' and '7'
Control. Length 1
15 Characters 50 Characters
'1' and '5' '5' AND '0'
Gryphon™ I GD4100/GM4100
Fixed