SpectraLink NetLink e340 Configuration And Administration Manual page 42

SpectraLink Corporation
The LINE display will indicate if a line is forwarded by a
destination address.
If any line is forwarded, the standby screen will display forwarding status. If the do-
not-disturb feature is enabled, the forwarding status will be pre-empted by the
display.
Not Disturb
If a given contact number has multiple appearances on the handset, forward
the lowest line appearance to forward all calls to that number on any line
appearance.
Transfer
In order to transfer an active call, press
you a dial tone for a second call on the same line appearance. Dial the number that
you want to forward the call to and then press
called and your call is disconnected. This is a blind transfer. For a consulted transfer,
press FCN 1 , dial the number, and then press the
answers, have your conversation and then press
disconnect the first call.
If the second call on the active line appearance is already in use, a consulted transfer
is made to the party on that call. Press
converse with the second call. Press
disconnect both calls.
Do not disturb
Activate the do-not-disturb feature to reject all incoming calls with a busy indication
by pressing FCN 2
again to resume ringing.
When the do-not-disturb feature is enabled, the standby screen will display
Disturb.
Voicemail
When any proxy has outstanding messages, the voicemail icon will display. Dial the
number assigned to message retrieval and follow system instructions to retrieve
messages. Alternately, if a PROXYn_MAIL_ACCESS value has been configured for
the corresponding proxy, the voicemail system can also be accessed by pressing the
softkey, which will appear after selecting a line and before beginning to dial.
Msg
The menu will display a plus (
LINE
that line. Indications are cleared when the handset receives notification that all new
voicemail messages have been read.
PN: 72-1089-02-E.doc
Configuration and Administration—NetLink e340/h340/i640 Wireless Telephone
FCN 1
FCN 1
FCN 1
. The handset will not ring for new incoming calls. Press
) indication when there is a new voicemail for
+
> character followed by the
. This places the call on hold and gives
again. The dialed number is
FCN 1
Dial softkey. When the party
to transfer the held call and
FCN 1
to place the first call on hold and
again to transfer the held call and
with SIP
Do
FCN 2
Do Not
Page 42