Configuring The Vcs As A Traversal Client; Overview; Adding A New Traversal Client Zone - TANDBERG VCS Administration Manual

Firewall Traversal

Overview

To enable your VCS to act as a traversal
client on behalf of its endpoints and neighbor
gatekeepers, you must create a connection
between it and a traversal server (e.g. a VCS
Border Controller).
You do this by adding a new traversal client
zone and configuring it with the details of the
traversal server.
Getting System
Introduction
Started Overview
D 14049.01
07.2007

Configuring the VCS as a Traversal Client

Adding a New Traversal Client Zone

•
VCS Configuration > Zones.
You will be taken to the Zones page.
Select New.
You will be taken to the Create Zone page.
•
xCommand ZoneAdd
Name
Enter the name you wish to give to this zone.
The name acts as a unique identifier, allowing
you to distinguish between zones of the same
type.
Type
From the Type drop-down menu, select
TraversalClient.
Create Zone
Click here to create the zone. You will be
taken directly to the Edit Zone page, where
you can configure the traversal client zone as
required.
You can create more than one
traversal client zone if you wish to
connect to multiple traversal servers.
System H.323 & SIP Registration
Configuration Configuration Control
Zones and Call
Neighbors Processing
0 0
TANDBERG VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
Firewall Firewall Bandwidth
Maintenance
Traversal Traversal Control
Appendices